We did a Foiled Wine Label for our good friends at The Measure. It was used for their Christmas / End of Year gift to their clients. Designed by the guys at The Measure.
Today we put up our Laser Cut Mosaic Screen in our mezzanine studio.
We got our Joiner, Rex Casson from Naramaa Joinery, to make a rail for the top and bottom anchor points. He used a beautiful old piece of Camphor Laurel he had at his factory.
The panels themselves are Laser Cut from 3mm MDF Board. We used MDF because it is nice and cheap and the Laser loves cutting it.
We used a rail system with stainless steel wires and clamps to hold the panels in place. We intend to change the image every few months, so the rail system gives us the flexibility to switch the size and the amount of panels used.
It turned out great! The best thing is, you can see it from both upstairs in the studio and downstairs in the front reception. Drop by and check it out!
Here is a project we did for BDA Architecture on the Gold Coast. It is a Laser Cut Land Contour Model for a development in Malaysia.
It took almost a full week for Robbie to set up all the files, cut each individual layer and then stick each layer on top of each other, in the right order.
We had to do it in 4 sections because it had to be shipped to Malaysia.